Difference between revisions of "Officers:Seaxes & Viking War Knives"
|Line 1:||Line 1:|
Revision as of 19:31, 19 June 2017
i) The blade and tang must be made from steel. They must be rust and burr free and must be of good overall construction and condition.
ii) The blade edge must be no less than 2mm and no more than 5mm (1/5”) in thickness. In cross section, the edge may be rounded or round shouldered but must not be square edged. The edges of a weapon must include its cutting surface and any back edges also.
iii) Seaxes with a blade exceeding 200mm (8”) in length must be made entirely of spring steel.
iv) The seax tip should be rounded to no less than an 18mm (11/16”) diameter. (i.e. the diameter of a 1999 5 pence piece). Any angle on the back of the seax that is must be rounded over.
v)The blade should not be parallel-edged (back edge to cutting edge).
vi) The blade should not be parallel-sided.
vii) The blade may have a narrow fuller in one or both sides.
viii) Seaxes may have small ferrules on the hand-grip but must not have a properly developed crossguard or a pommel.